Rascal 600T Owner's Manual

Rascal 600T Owner's Manual Manual pdf 31 page image

Rascal R600 Scooter Owner’s ManualEMC Part: 19271200 • Rev. 03 • 06/01/2003261. Remove Seat, Batteries, Dash or Tiller, and Front Section as described previously.2. With the unit still standing upright on the rear bumper, disconnect both electrical connectors (4prong and 2 prong) of the Drivetrain Power Harness. Remove both of the Quick Disconnect Pinsused to hold leaf springs into position.3. Grasp the top center of the frame and the seatpost. Rotate unit out and lift straight up.Transporting your ScooterBy Car — To transport your disassembled scooter by car, place each of the components into the trunk,being careful not to scratch or mark any of the finished surfaces. Make sure the batteries are right sideup and on a level spot in your trunk. If you need assistance lifting weights, consider asking ElectricMobility’s Customer Service Department or your authorized service center about the Power Trunk Lift.This device will assist you in transporting your scooter by transferring these components in and out ofyour trunk with very little effort. (See “Specifications” for more information on weights).By Airplane — To transport your unit on an airplane, we recommend that you call your airline at least24 hours in advance to ensure that they are aware of your scooter. Your Rascal batteries are approvedfor airline travel. Ask specifically where and with whom you should drop the unit off and where and withwhom you should retrieve it at your destination.Remember to bring this manual with you as a reference on your trip. Your manual will assist you indisassembling and re-assembling your unit if required.Prior to leaving the airport, remember to test the unit out when first getting on it. Direct any questionsto the airline personnel if the unit does not work as it did prior to transportation.If traveling outside of the United States, you may require a different charger or an adapter for yourpresent charger. Customer Service or your authorized service center can help you answer thesequestions and supply you with the charger or adapter you require.By Bus, Van or Truck without Disassembly — If transporting your scooter fully assembled in a van,bus, or truck, secure it to the floor using a four point tie-down system. Make sure that the batterytiedown straps are secure prior to transportation.The operator of the scooter should then be seated in an approved seat in the transporting vehicle.WARNING!This scooter does not meet Federal Safety Standards for motor vehicleseating. Do not sit, nor permit anyone else to sit, in the seat of yourscooter during transportation in a motor vehicle as this poses asignificant risk of bodily injury or even death.