43 / 44Use FileHub as a Power BankUse FileHub as a power bank to charge your mobile device bysimply connecting it to your devices via the USB charging cable.Check the remaining battery level by pressing the Power Button.SpecificationsModelInputWi-Fi SpeedStandardsFrequency BandBattery CapacityPlay TimeTemperature & HumidityDimensionsWeightRP-WD009DC 5V / 2A733Mbps (300Mbps@2.4GHZ;433Mbps@5GHz)IEEE 802.11ac/802.11n2.4GHz / 5GHz6700 mAh Li-ion2.4G: 8.4 hours5G: 6 hoursOperating: 5°C-40°C (41°F-104°F) /5%-90% RH (Non-condensing)Storage: 0°C-60°C (32°F-140°F) /5%-90% RH (Non-condensing)113 x 76 x 25mm / 4.4 x 3.0 x1.0in199.4g / 7.0ozFAQQ: How do I restore my RAVPower Filehub to factory settings?1. Make sure it’s connected to a mobile device or laptop via the USB cable.2. Press and hold the Reset Button for 10 seconds with a needle or atoothpick.3. Wait for the router to reboot.4. Or you can find the Restore to factory default setting in the routeradmin system (10.10.10.254) by Settings -> System -> Reset Settings.Q: How do I update the firmware?1. Power on the Filehub, connect to its local Wi-Fi network. Log in on the10.10.10.254 webpage.2. Connect an SD card to the Filehub. Put the firmware file inyour cellphone or laptop which accessing to 10.10.10.254 instead of theUSB storage.3. Go to Settings -> System -> Firmware Upgrade -> Select firmware fromyour cellphone or laptop -> Save -> wait to finish and reboot.Q: The “RAV Filehub” app cannot find the USB storage device after Iplugged it into the product.1. Unplug to power off the Filehub.2. Unplug the USB disk and plug it into the Filehub again.3. Plug to power on your Filehub again with the USB storage plugged in.4. You can also access the file of your USB drive via the router adminsystem on 10.10.10.254.Q: My Filehub is unresponsive when I enter the admin webpage10.10.10.254.Make sure you device is connected to the router. It may disconnect fromthe router when you are changing settings without your notice. Makesure it stays connected with the Filehub.