RaySat T7 Installation Manual
                                    | |
Contents
| 
T7 Installation & User Manual 218 Antenna Cable InstallationThis section provides procedures to proper routing of the RF cable from the antenna to the mobile receiverinside the vehicle.8.1 Routing Cable on the Roof1. Attach one end of the receive cable to the antenna. Use the provided SMA wrench to tighten theconnector (Figure 8-1). Be careful not to over-tighten the connector. Only turn until the connector is snug.2. Route the cable to the point of entry (POE). Secure the cable along the crossbars or side rails of thevehicle’s roof rack system (Figure 8-2). Use tie-wraps or self adhesive cable straps to secure the cable.Some vehicles have rubber trim along the edge of the vehicle’s roof that may allow the cable to be hidden.Be careful not to pinch or bend the cable when routing it below side rails.Figure 8-1 Attach the cable to the antenna Figure 8-2 Secure the cable on the outside of the vehicleTools and Installation:Be sure to seal the POE with silicone or equivalent sealant.This will prevent water from penetrating into the vehicle. |
Related manuals for RaySat T7
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine