RaySat T7 Installation Manual
                                    | |
Contents
| 
T7 Installation & User Manual2611 Receiver ConnectionsThe following chapter will explain the procedures for properly connecting all system cables to the receiver.Key Note:Be sure to record the smart card, receiver and antenna serialnumbers. These numbers will be used to activate the system.Caution:Do NOT remove the cover of the receiver. Do NOT obstructor place anything into the ventilation slots of the receiver.Damage to the unit or injury may occur due to exposedvoltage. Do NOT place the receiver in a location where itmay be exposed to any type of moisture. This may result inelectrical shock or fire.Caution:Make sure that the power to the receiver isdisconnected from the power source BEFOREconnecting or removing any cables from the receiver.11.1 Wiring Configurations1. Connect the antenna cable coming from the antenna to the ANTENNA port of the receiver.2. Connect the A/V cables to the A/V ports on the receiver.3. Connect the power cable to the PWR IN port on the receiver.Figure 10-1 Mobile receiver connectionsAntennacable PowercableSmartcardA/V cables |
Related manuals for RaySat T7
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine