Raymarine G-Series Installation Instructions Manual
Also see for G-Series system: Installation & commissioning instructionsQuick reference guideQuick referenceInstallation instructionInstallation instructions
      | |
G-Series Command Center KeyboardInstallation instructionsWaste Electrical and Electronic Equipment DirectiveThe Waste Electrical and Electronic Equipment (WEEE) Directive requiresthe recycling of waste electrical and electronic equipment. Whilst the WEEEDirective does not apply to some of Raymarine’s products, we support itspolicy and ask you to be aware of how to dispose of this product.The crossed out wheelie bin symbol, illustrated above, and found on ourproducts signifies that this product should not be disposed of in generalwaste or landfill.Please contact your local dealer, national distributor or Raymarine TechnicalServices for information on product disposal.DisclaimerThe technical and graphical information contained in this document, to the best of ourknowledge, was correct as it went to press. However, our policy of continuous improve-ment and updating may change product specifications without prior notice. As a result,unavoidable differences between the product and handbook may occur from time totime. Raymarine cannot accept responsibility for any inaccuracies or omissions it maycontain. For the latest product information visit our website - www.raymarine.comEMC installation guidelinesRaymarine equipment and accessories conform to the appropriate ElectromagneticCompatibility (EMC) regulations. This minimizes electromagnetic interference betweenequipment, which could otherwise affect the performance of your system.Correct installation is required to ensure that EMC performance is not compromised.For optimum EMC performance, we recommend that:Raymarine equipment and the cables connected to it are:i. At least 3 ft. (1 m) from any equipment transmitting or cables carrying radiosignals e.g. VHF radios, cables and antennas. In the case of SSB radios, thedistance should be increased to 7 ft. (2 m).ii. More than 7 ft. (2 m) from the path of a radar beam. A radar beam cannormally be assumed to spread 20 degrees above and below the radiatingelement.• Raymarine specified cables are used.• Cables are not cut or extended.Always allow the maximum separation possible between different items of electricalequipment. This will provide the best conditions for EMC performance for theinstallation.Technical specificationProduct installationThis equipment must be installed and operated inaccordance with the Raymarine instructionsprovided. Failure to do so could result in poorproduct performance, personal injury, and/ordamage to your boat.Service and MaintenanceThis product contains no user serviceablecomponents. Please refer all maintenance andrepair to authorized Raymarine dealers.Unauthorized repair may affect your warranty.Ultra violet lightTo provide protection against the damagingeffects of ultra violet (UV) light, the sun covershould be placed on the unit when not in use.CleaningDO NOT use acid, ammonia based or abrasiveproducts.DO NOT use commercial high pressure washing(jet wash) equipment.Approvals:CE - conforms toFCC- conforms toAdditional conformanceEN60945, EN300-440-2CFR47 PART 15IC-RSS-210Size 297 x 98 x 46Weight 0.65 kgMounting Dash mountHandheld (with optional wireless upgrade)Supply voltage 9 V to 16 VPower consumption 1.5 WEnvironmental conditions: operating temperature: -15°C to 55°C (5°F to 131°F)non-operating temperature: -25°C to 70°C (-13°F to158°F)relative humidity limit: 95%water protection:waterproof to CFR-46 standardStorage conditions whenpacked:Temperature : -25°C to 55°C (-13°F to 158°F)relatiive humidity: 75%LEN 3Raymarine plcAnchorage Park,Portsmouth,Hampshire PO3 5TDUnited KingdomRaymarine Inc.21 Manchester Street,Merrimack,New Hampshire 03054-4801USA |
Related manuals for Raymarine G-Series system
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine