Raymarine ST6000 Service Manual

Also see for Autohelm ST6000: Operation manual Service manual

Contents

Raymarine ST6000 Service Manual Manual pdf 23 page image

AutohelmAutohelmAutohelmAutohelmSeaTalk Service Manual 196. Special functions.6.1 Display of Software VersionIt is possible to display the version number of both Course Computer and ControlUnit software installed in a particular system. This is achieved by pressing both the+10 and -10 keys together for 2 seconds and releasing. The display will show theControl Unit Version (65 followed by Issue Level) for 10 seconds, followed by CourseComputer Version (66 followed by Issue Level). The pilot must be in standby mode atthe time. Each version is displayed for 10 seconds before the pilot reverts to standby.A software history for each product is shown in the relevant Service Section.6.2 Permanent Watch Alarm Mode.The ST7000 autopilot can be set up in a permanent watch alarm mode, as requiredby the Sea Fish Industry Authority (S.F.l.A).It must be stressed that the selection of this mode is permanent and can only bereversed by returning the Course Computer to Nautech.Permanent Watch Alarm is achieved by first entering the calibration menu. Once incalibration, regardless of display message, press the Auto, Standby, and Track keystogether for 1 second before releasing. The display will now show ‘SELECT WATCH’.The user now has 10 seconds to select permanent watch alarm mode by againpressing Auto, Standby and Track together for 1 second. The display will then show‘WATCH ON’ for 10 seconds before reverting back to ‘CAL’. A normal exit fromcalibration mode must now be executed.6.3 Display Test Mode.All display segments on the control unit can be switched on by pressing the +10, -10,Standby and Display keys together. This mode can only be accessed after the unithas been powered up with the yellow SeaTalk data wire open circuit. (This is bestdisconnected in the Course Computer Connector box (Bus 1 and Bus 2).)6.4 LCD Contrast Ratio Adjustment.In certain circumstances, it may be necessary to adjust the contrast ratio of the Z082Control Unit LCD. This procedure is detailed in Section 4 of the ZO82 Control UnitSection.