Raymarine ST70 User's Reference Manual

Also see for ST70 Instrument: Installation guide Operating guide User reference guide User reference handbook Installation guide

Raymarine ST70 User's Reference Manual Manual pdf 23 page image

Chapter 2: Commissioning Procedures 175. Press ENTER to display the response adjust boxfor the data you have selected.6. Use < or > to set the response rate. A highervalue gives a quicker response rate and viceversa.7. Press ENTER to save the value and return tothe Response menu.8. If you want to change the response for otherdata types, use < or > to scroll to the requireddata type, then repeat steps 5 to 8.9. To leave response setup, ensure the Response menu is displayed, then:i. Press CANCEL to return to the Display Settings menu.ii. Press CANCEL to return to the Main Menu.iii. Press CANCEL to return to the operational page.Ending dockside setupDockside setup is complete when you have satisfactorily carried out the initial setupprocedures and correctly set the:• Depth offset.• Water temperature.• Magnetic variation.• Ground wind calculation method.• Response rate.When Dockside setup is complete, return to the operational page, then carry out aSeatrial calibration.2.2 Seatrial calibrationWARNING: Ensure you have sufficient sea room for calibrationThe seatrial calibration maneuvers require a sufficiently clear area ofwater. Ensure you are not likely to collide with any vessel or obstructionduring calibration.When the dockside calibration procedures are complete, navigate to a place whereyou have plenty of sea room then carry out the seatrial calibration procedures. Theseset the ST70 instrument so it gives an optimum performance with the systemtransducers. The seatrial calibration comprises:• Wind calibration & alignment.• Speed calibration.When you have completed the appropriate seatrial procedures, proceed to Return tonormal operation.12Press ENTER to acceptSpeedi < & > adjust response level.CANCEL exits without savingD10089-1