Icon DescriptionRear-view mode — image is flipped horizontally.Zoom setting: 2x zoom.Zoom setting: 4x zoom.Single active controller on network.Multiple active controllers on network.PC / laptop detected on network.Point mode enabled.Point mode disabled.Stabilization Off.Stabilization On.FFC (Flat Field Correction)Periodically the camera will perform a Flat Field Correction (FFC).This will fine tune the thermal image to suit the current ambienttemperature.The FFC operation is indicated by a momentary pause and a greenrectangle displayed in the upper left of the thermal video image.19.3 Controls overviewThe thermal camera application is available on compatibleRaymarine multifunction displays and systems. It includes controlsfor the thermal camera.Thermal camera application – hardkey controlsRotary control Zoom image in / out.Joystick / trackpad • Pan and tilt cameraNote: On touchscreen displays you canalso use the touchscreen to pan and tiltthe camera.• Navigate menusOK Confirm menu selectionCANCEL / Back Cancel selectionRANGE IN / OUT Zoom image in / out.Thermal camera application menu.The following menu options are available in the thermal cameraapplication.Activate Camera Brings the thermal camera out ofstandby mode. (only available whencamera is in standby.)Pause Image • On• Off (default)Camera Home Selecttoreturnthecameratoitshomeposition.Image Options Select to display the Image Optionssub-menu.• Color• Scene• Thermal / Visible• Reverse video• Rear View• SurveillanceAdjust Contrast Select to display the Adjust Contrastsub-menu.• Contrast• Brightness• ColorStandby Select to place the camera in tostandby mode. (only available whencamera is activated.)Camera Set-up Select to display the Camera Set-upsub-menu.• Set Home Position• Slew Settings• Align Camera• Elev Align:• Surveillance Settings• Default Color• Icon Level• Stabilization Mode• Point Mode• Ball Down Mode• High Power Standby• High Power TorqueUsing the thermal camera application 221
