17.18 Fishfinder waypointsPlacing a waypoint on the fishfinder display enables you to marka position so that you can return to it later.When a waypoint is placed, its details are added to the waypointlist and a vertical line labelled WPT is displayed on-screen. Thewaypoints can then be navigated to using the chart application.Placing a Waypoint in the fishfinderapplicationFrom the fishfinder application:1. Select and hold the required location.The fishfinder context menu is displayed.2. Select Place Waypoint.Placing a waypoint using the WPT button oriconFrom the fishfinder application:1. Select WPT.The waypoint menu is displayed.2. Whilst the waypoint menu is open:• Select WPT again to place a waypoint at your vesselsposition, or• Select the appropriate option: Place Waypoint At Vessel,Place Waypoint At Cursor or Place Waypoint At Lat/lon.Placing a Waypoint using the context menuYou can place a waypoint in the fishfinder application using thecontext menu.1. Open the fishfinder context menu.2. Select Place Waypoint.The Waypoint is placed at the cursors location and aconfirmation pop-up is displayed.3. Select Ok to confirm waypoint placement, or4. Select Edit to edit the new waypoints details.17.19 Fishfinder alarmsThe display can be configured to provide a number of fishfinderalarms.The following fishfinder alarms can be set when a sonar moduleis detected, or when the simulator is on:• Fish — alarm sounds when a target meets the specifiedsensitivity level and, is within the depth limits (if enabled). Thegreater the fish alarm sensitivity, the greater the number oftarget image depths displayed.• Fishfinder Deep — alarm sounds when the sonar moduledetects that the depth is greater than the deep limit.• Fishfinder Shallow — alarm sounds when the sonar moduledetects that the depth is less than the shallow limit.Setting up fish alarmsFrom the Alarms menu homescreen > Set-up > Alarms:1. Select Fish.The Fish alarms menu is displayed.2. Select Fish so that On is highlighted.3. Select Fish Sensitivity.The fish sensitivity numeric adjust control is displayed.4. Adjust the fish sensitivity to the require value.The greater the fish alarm sensitivity, the greater the numberof target image depths displayed.5. Select Fish Depth Limits so that On is highlighted.The shallow and deep fish limit settings will be activated inthe menu.6. Select Shallow Fish Limit.The shallow fish limit numeric adjust control is displayed.7. Adjust the value to the require setting.8. Select Ok to confirm the new value and close the numericadjust control.9. Select Deep Fish Limit.The deep fish limit numeric adjust control is displayed.10.Adjust the value to the require setting.11.Select Ok to confirm the new value and close the numericadjust control.Setting up fishfinder deep alarmFrom the Alarms menu homescreen > Set-up > Alarms:1. Select Fishfinder Deep.2. Select Deep so that On is highlighted.Selecting Deep will switch between On and Off.3. Select Deep Limit.The deep limit numeric adjust control is displayed.4. Adjust the setting to the required value.5. Select Ok to confirm the new value and close the numericadjust control.Note: The Deep Limit cannot be set to less than the ShallowLimit.Setting up fishfinder shallow alarmFrom the Alarms menu homescreen > Set-up > Alarms:1. Select Fishfinder Shallow.2. Select Shallow so that On is highlighted.Selecting Shallow will switch between On and Off.3. Select Shallow Limit.The shallow limit numeric adjust control is displayed.4. Adjust the setting to the required value.5. Select Ok to confirm the new value and close the numericadjust control.Note: The Shallow Limit cannot be set to greater than theDeep Limit.200 New a Series / New c Series / New e Series
