Raymarine axiom 7 Installation Instructions Manual

Also see for AXIOM: Basic operation instructions Advanced operation instructions Advanced operation instructions

Contents

Raymarine axiom 7 Installation Instructions Manual Manual pdf 9 page image

Chapter 1: Important informationWarning: Product installation and operation• This product must be installed and operated in accordance with the instructionsprovided. Failure to do so could result in personal injury, damage to your vesseland/or poor product performance.• Raymarine recommends certified installation by a Raymarine approved installer.A certified installation qualifies for enhanced product warranty benefits. Contactyour Raymarine dealer for further details, and refer to the separate warrantydocument packed with your product.DisclaimersRaymarine does not warrant that this product is error-free or that it is compatible with productsmanufactured by any person or entity other than Raymarine.This product uses digital chart data, and electronic information from Global Navigation SatelliteSystems (GNSS) which may contain errors. Raymarine does not warrant the accuracy of suchinformation and you are advised that errors in such information may cause the product to malfunction.Raymarine is not responsible for damages or injuries caused by your use or inability to use theproduct, by the interaction of the product with products manufactured by others, or by errors in chartdata or information utilized by the product and supplied by third parties.This product supports electronic charts provided by third party suppliers which may be embedded orstored on memory card. Use of such charts is subject to the supplier’s End-User Licence Agreement.RF exposureThis equipment complies with FCC / IC RF exposure limits for general population / uncontrolledexposure. The wireless LAN / Bluetooth antenna is mounted behind the front facia of the display.This equipment should be installed and operated with a minimum distance of 1cm (0.39in) betweenthe device and the body. This transmitter must not be co-located or operating in conjunction with anyother antenna or transmitter, except in accordance with FCC multi-transmitter product procedures.Compliance Statement (Part 15.19)This device complies with Part 15 of the FCC Rules. Operation is subject to the following twoconditions:1. This device may not cause harmful interference.2. This device must accept any interference received, including interference that may causeundesired operation.FCC Interference Statement (Part 15.105 (b))This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses, and can radiate radio frequency energyand, if not installed and used in accordance with the instructions, may cause harmful interference toradio communications. However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio or television reception, whichcan be determined by turning the equipment off and on, the user is encouraged to try to correct theinterference by one of the following measures:1. Reorient or relocate the receiving antenna.2. Increase the separation between the equipment and receiver.Important information 9