Raypak 0133-4001 WH Installation And Operating Instructions Manual

Also see for 260: Installation & operating instructions Installation & operating instructions Brochure & specs

Contents

Raypak 0133-4001 WH Installation And Operating Instructions Manual Manual pdf 34 page image

PILOT BURNER FLAME-IID(atmospheric units)Inspect on the first and third month after initial start-up and then on an annual basis. If problems are found,refer to the Troubleshooting sections of this manual foradditional directions.1. Remove top of heater and inspect heat exchangerfor soot and examine venting system.2. Remove rear header and inspect for scale depos-its.*3. Inspect pilot and main burner flame and firing rate.*4. Inspect and operate all controls and gas valve.*5. Visually inspect system for water leaks.*6. a. Oil pump motor and bearing assembly, if oilcups are provided.b. Disconnect pump from header and checkcondition of pump impeller. Check condition ofbearing by attempting to move impeller fromside to side. Replace any parts showing wear.c. Check pump coupler for wear and vibration.7. Check flow switch paddle.8. Clean room air intake openings to assureadequate flow of combustion and ventilation air.CAUTION: Combustion air must not be contaminatedby corrosive chemical fumes which can damage theheater and void the warranty.9. Keep heater area clear and free from combustiblematerials, gasoline, and other flammable vaporsand liquids.*Should be checked monthly.(Takes approximately 15 minutes).INSPECTION PROCEDURES34Fig# 9336