Raypak RAYTHERM 0133-4001 Installation And Operating Instructions Manual

Also see for 0133-4001: Installation and operating instructions

Raypak RAYTHERM 0133-4001 Installation And Operating Instructions Manual Manual pdf 26 page image

1. Set the thermostat to lowest setting.2. Turn off all electric power to the appliance.3. Remove boiler door.4. Push in gas control knob slightly and turn clock-wise to ìOFFî. Do not force.5. Replace boiler door panel.1. STOP! Read the safety information above onthis label.2. Set the thermostat to lowest setting.3. Turn off all electric power to the appliance.4. Remove boiler door panel.5. Push in gas control knob slightly and turnclockwise to ìOFFî.NOTE: Knob cannot be turned from ìPILOTî to ìOFFîunless knob is pushed in slightly. Do not force.6. Wait five (5) minutes to clear out any gas. Thensmell for gas, including near the floor. If yousmell gas, STOP! Follow ìBî in the safety in-formation above on this label. If you donít smellgas, go to next step.7. Locate pilot mountedon the right side of theburner tray, and rightof first burner.8. Turn knob on gas controlcounter-clockwiseto "PILOT"9. Push in control knob all the way and hold in .Immediately light the pilot with a match. Continueto hold the control knob in for about one (1) minuteafter the pilot is lit. Release knob and it will popback up. Pilot should remain lit. If it goes out, re-peat steps 5 through 9.ï If knob does not pop up when released, stopand immediately call your service technicianor gas supplier.ï If the pilot will not stay lit after several tries,turn the gas control knob to ìOFFî and callyour service technician or gas supplier.10. Stand to the side of the boiler and turn the gascontrol knob counter-clockwise to "ON".11 Replace boiler door panel.12. Turn on all electric power to the appliance.13 Set the thermostat to the desired setting.PILOT THERMO-BURNER COUPLEA. This appliance has a pilot which must be lightedby hand. When lighting the pilot, follow theseinstructions exactly.B. BEFORE LIGHTING smell all around the appli-ance area for gas. Be sure to smell next to thefloor because some gas is heavier than air andwill settle on the floor.WHAT TO DO IF YOU SMELL GASï Do not try to light any appliance.ï Do not touch any electric switch; do not useany phone in your building.ï Immediately call your gas supplier from aneighborís phone. Follow the gas supplierísinstructions.ï If you cannot reach your gas supplier, callthe fire department.C. Use only your hand to push in or turn the gascontrol knob. Never use tools. If the knob willnot push in or turn by hand, donít try to repair it,call a qualified service technician. Force or at-tempted repair may result in a fire or explosion.D. Do not use this appliance if any part has beenunder water. Immediately call a qualifiedservice technician to inspect the appliance andto replace any part of the control system andany gas control which has been under water.WARNING: If you do not follow these instructions exactly, a fire or explosion mayresult causing property damage, personal injury or loss of life.START-UPLIGHTING INSTRUCTIONS FOR BOILERS WITH STANDING PILOT. For Models 133, 182, 260, 330 & 400Fig. # 8081.0GAS CONTROLKNOB SHOWNIN "OFF"POSITIONGAS INLET Fig. # 8243.0GAS CONTROLKNOB SHOWNIN "OFF"POSITIONGAS INLET26TO TURN OFF GAS TO APPLIANCELIGHTING INSTRUCTIONSFOR YOUR SAFETY READ BEFORE LIGHTING