RedMax 122HD45 Operator's Manual

CAUTION: Small errors can influencethe ratio of the mixture drastically when youmix small quantities of fuel. Measure thequantity of oil carefully and make sure thatyou get the correct mixture.1. Fill half the quantity of gasoline in a clean containerfor fuel.2. Add the full quantity of oil.3. Shake the fuel mixture.4. Add the remaining quantity of gasoline to thecontainer.5. Carefully shake the fuel mixture.CAUTION: Do not mix fuel for morethan 1 month at a time.To fill the fuel tankWARNING: Obey the procedure thatfollows for your safety.1. Stop the engine and let the engine become cool.2. Clean the area around the fuel tank cap.3. Shake the container and make sure that the fuel isfully mixed.4. Remove the fuel tank cap slowly to release thepressure.5. Fill the fuel tank.CAUTION: Make sure that there isnot too much fuel in the fuel tank. Thefuel expands when it becomes hot.6. Tighten the fuel tank cap carefully.7. Clean fuel spillage on and around the product.8. Move the product 3 m/10 ft or more away from therefueling area and fuel source before you start theengine.Note: To see where the fuel tank is on your product,refer toProduct overview on page 2.To adjust the handleFor 122HD60 only:The rear handle can be adjusted into 5 positions.• Release the handle lock and turn the handle.To start the product with a cold engine1. Pull the choke control to choke position.2. Push the air purge bulb approximately 6 times oruntil the bulb starts to fill with fuel. It is not necessaryto fill the air purge bulb fully.3. Hold the body of the product on the ground with yourleft hand. Do not step on the product.4. Pull the starter rope handle slowly with your righthand until you feel some resistance, then pull thestarter rope handle quickly and with force.994 - 008 - 30.01.2021 9