RedMax CHTZ600 Workshop Manual

11. Remove the gasket (A).A CEDBFGKHIJ12. Remove the wear plate (B).13. Remove the seal (C).14. Remove the connecting rod (D).15. Remove the 2 screws (E) and the nuts (F).16. Remove the cutting attachment.17. Remove the needle bearing (G).18. Remove the gear wheel (H).19. Remove the needle bearing (I).20. Remove the connecting rod (J).21. Remove the wear plate (K).22. Put the clutch drum in the thread holes in the gearhousing to lock in position. Use a gear drive removaltool to remove the gear drive. Refer toServicingtools on page 12.23. Push the gear drive out of the ball bearing andremove the clutch drum from the gearbox housing.24. Remove the ball bearing from the gearbox housing.CAUTION: Install the connection rods withthe text in the direction of the gear wheel.CAUTION: Replaced or cleaned parts mustbe lubricated on all sides. Use Redmaxbevel gear grease. Refer toServicing toolson page 12 andServicing data on page 6.7.10.2 To clean and examine the clutch, clutchdrum and gearbox• Examine the clutch drum for wear.• Examine all the parts. Replace parts, if it isnecessary.• Examine the clutch and the clutch springs fordamages.1108 - 001 - 24.11.2020 Repair instructions - 37