Reefe RainPro RM5000 Installation Manual & Owners Information

Page 6 Ascento Group Australia P: 1800 807 604 E: csv@ascento.com.au WaterMark Quality System Doc # RQS.105911) If the pump has a float switch, ensure it CANNOT get stuck on the side of the tank orunder baffles or similar - warranty service does not cover this situation. FOR PUMPS WITHFLOATS: The water level will need to be 0.6m to 1.2m high inside the tank, for the pumpto start.12) Isolation valves must be fitted (ball-valve or gate-valve) on Mains supply and discharge.13) A Barrel-Union must be fitted external of the tank to allow easy servicing of the pump,install it after the elbow to avoid it twisting loose from the pump starting & stopping.14) It is the INSTALLERS responsibility to check the pumps operation prior to leaving the siteCHECK ALL CONNECTIONS: Ensure all fittings and joints are watertight and airtight. Leakswill cause the pump to cycle on & off continuously, this is not a fault of the pump.15) All Electrical Wiring & Power Outlet & Cable protection must be in accordance withapplicable Australian Standards.16) IRRIGATION USE - MANDATORY REQUIREMENTS FOR ALL INSTALLATIONS: For anyinstallation of pumps supplying irrigation, you must fit an 18L or larger pressure tank.Set tank air pressure: RPS036 set air pressure to 250kPa, RPS050 set air pressure to 350kPa17) IMPORTANT NOTICE RE THE STOPPING FUNCTION: In some situations the pump will cyclea few times after each use. THIS IS NOT A WARRANTY FAULT, it is a normal function ofthe internal pump controller releasing excess pressure when there is some “bounce” or“give” in the pipework or connected fixtures – it is often caused by toilet cisterns or ashort discharge pipe or flex in pipes. It is not a fault with the pump. If the owner does notwant this to occur, install a 2L or larger Pressure Tank, set the tank air pressure: RPS036set air pressure to 250kPa, RPS050 set air pressure to 350kPa.18) IF THE PUMP BLEEDS OUT OF THE TOP After startup, the pump may bleed water out of thetop of the pump – this is NOT a fault, it is the normal operation of the pump.19) Some air can be pumped when the tank is low in water – this is not a fault it is normaloperation.20) WARNING: NO RCD/SAFETY SWITCH IN THEPOWER CIRCUIT? DO NOT INSTALL PUMPS!!21) WARNING: DO NOT ATTEMPT ELECTRICAL REPAIRS OF ANYSORT UNLESS YOU ARE AN AUSTRALIAN-LICENSED ELECTRICIAN