Regency City CB50E Owners & Installation Manual

Also see for 686-927: Owners & installation manual

58 | City Series CB50EinstallationIMPORTANT INSTALLATION NOTE:The battery holder must be placed inside the supplied (low voltage) junction type wall box and installed intothe wall only.DO NOT INSTALL WITHIN THE CONFINES OF THE FIREPLACESWITCH MUST BE ACCESSIBLEBattery Holder Installation1. Install the low voltage junction box to the framing, at desired location within 11-1/2 ft. from fireplace.2. Feed the 6 pin connector wiring harness through the opening at back of junction box. The wiring harnessis located on the right hand side and must be installed prior to finishing.3. Connect the 6 pin connector to the back of the Battery Holder.4. Install the Battery Holder in the Low Voltage Junction box.5. Insert the 4 AA type batteries (optional) in the battery compartment with the correct polarity.Note: Batteries are only required for non power vent model. Batteries are only a secondary power source if120 VAC power is lost. Batteries should only be placed inside the compartment if there is no 120 VACsupplied to the appliance or 120VAC power has been lost within home.6. Place the slider into the cover plate.7. Put the Battery Holder switch in the “OFF” position, to allow correct lineup for slider switch.8. Make sure the Battery Holder and cover plate words “ON” and “UP” are on the same side.9. Align the slider with the switch on the Battery Holder and couple the switch into the slider.10. Align the screw holes.11. Using the two (2) screws provided secure the cover plate to the Battery Holder.12. For coding instructions, see full details in this manual.Proflame Battery HolderWall Mount On / Off Switch and Battery Holder InstallationRequired for all installationsONREMOTEOFF1623415Item Part No. Description1 N/A Slider Switch (included withwall plate)2 911-335 Wall Plate - White911-343 Wall Plate - Black3 911-337/P Battery Holder4 N/A J-Box5 910-369 Low Voltage Junction Box6 911-181 Battery Holder Wire Harness2