Regency Energy U31-NG10 Owners & Installation Manual

Also see for Energy U31: Brochure & specs Specification sheet Owners & installation manual Owners & installation manual

Regency Energy U31-NG10 Owners & Installation Manual Manual pdf 20 page image

20 | Regency U31-10 Gas Fireplace Insert|20installationDiagram 4Diagram 5Rear View: Trim AssemblyDiagram 2Diagram 3Rear View: Faceplate AssemblyDiagram 1STANDARD FACEPLATE &HEARTH TRIM INSTALL1. Lay the faceplate panels flat, face down onsomething soft so they don't scratch.2. Take the top faceplate and align the holes in it withthe holes in the side panels. Using the screwsprovided, attach from the top of the panel (theholes in the top panel are slightly larger thanthe holes in the side panel to facilitate easierinstallation). Diagram 1.Hint: Don't tighten the screws down completely atthis point, continue on with steps 3 and 4 anddo a trial fit to the unit. Make any necessaryadjustments and when it fits properly then tightendown the screws.Hearth Trim Option: Hearth Trim is an optionthat can be used to finish off the installationwhen the bottom of the fireplace is higher thanthe hearth or to raise the fireplace. Attach theHearth Trim to the bottom of the faceplate sidepanels with the screws provided. See Diagram1.3. Using the connectors provided, join the left sidetrim (with the ON/OFF switch) to the top trim.Diagram 2. Connect the right side trim to thetop trim.4. Place the trim on the assembled faceplatepanels, aligning the wire connections from theswitches with the notch on the left side panel.5. Connect the fan switch wires by taking theblack and red wires with the male ends (inthe grey harness) and connect them with thewire connectors from the fan speed control.6. Tuck the wires into the faceplate to keep themaway from the insert using the clip provided.Attach the clip to the rear of the faceplate toensure that the wires do not touch the sideof the unit. Diagram 3.7. The power cord should be run behind thefaceplate panel.8. Attach the brass trim to the faceplate bydrilling a 1/8" hole through into the faceplateusing the hole in the trim as a guide. Fastenthe trim to the faceplate panels using theplated screws. Diagram 4.9. Attach the faceplate panels to the insertbody using the 4 remaining black screws.Diagram 5.10. Push the Regency logo plate into the twoholes in the bottom left corner of the face-plate.