Regency GEM54-NG Owner's Manual

Also see for Gem54: Owners & installation manual

34 Regency Gemfire™ Gas FireplaceINSTALLATIONOPTIONAL STAINLESS STEELREFLECTIVE PANEL INSTALLATION1) Position the left side panel in place - top of panel in first, then fi t thebottom tab into the slot at the bottom of the fi rebox as shown below.Repeat for right side panel.Fit side panel tab into slotLeft SidePanelShownLeft side panel in position2) Fit the back panel into position by clearing the pilot shield - bottomof panel goes in first.Then fi t the tabs on the bottom left and right side of the back panelinto the slots at the base of the firebox.Secure the back panel in place by placing the brackets over thescrews on the top of the inside left and right side of the fi rebox andtighten the screw to hold the bracket against the back panel shownbelow.Right side back panel tab fitted into slotBracket shown in place on right side of the fireboxRight side panel in position90 degreebend facestowards centerof unit on bothleft and rightside panelsLeft SideBracketBefore you start:Stainless panels must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time. Claims for damage after installation willnot receive consideration.To protect the finish during installation and handling - cotton gloves MUST be worn at all times while handling the panels (even when removing protectivecoating).Stainless panels will discolor a little during normal operation. This is normal and should not be considered a defect.All hand and finger marks MUST be cleaned off with a soft cloth and a stainless steel cleaner. Most stainless steel cleaners leave a fi lm/residue on the surface ofthe panels. Use an ammonia based cleaner (ie. glass cleaner) to remove this fi lm before applying heat to the unit. Failure to do this will result in burn stain onpanels which you will be unable to remove. This is not a warranty item.Warning: Turn off the unit by way of the wall switch or remote. Allow unit to cool at least 10 min. - prior to removing faceplate.