Regency GF900L-NG Owners & Installation Manual

Regency GF900L Gas Fireplace 17INSTALLATIONVent restriction is required for certain venting installations, see the diagrams in the "VentingArrangements" section to determine if they are required for your installation.The Vent Restrictor plate is located on the inside top of the fi rebox.To set the vent restriction as indicated in the venting arrangements diagrams, refer to the following instructions;1. Remove the glass door and inner panels - see instructions in this manual.2. Remove 6 screws (3 front - 3 back) to remove heat baffl e to access restrictor plate.VENT RESTRICTOR POSITIONSet 0 - 75mm OpenSet 2 - 25mm openSet 3 - 18mm openSet 1 - 50mm openHeat Baffle3. Remove the screws that hold the vent restrictor in place.4. Adjust the vent restrictor plate to the required vent restrictor position asper the diagrams shown below.5. Once the vent restrictor plate is in the required position, secure with screws.