40 | Regency HZ33CE-10 Gas Fireplace|40installation919-265 07/10/13Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Brokenlogs can interfere with pilot operation.Improper positioning of the logs and lava embers may create carbon build-up and can alter the unit's performance which is not coveredunder warranty.*Satin paint is included if touch ups are required.1 Rear Log2 Left Log3 Right Log4 Front Right Log Piece5 Front Left Log Piece - HZ33CE OnlyLava Embers/RocksLog Clip - HZ33CE onlyLog Brackets - HZ33CE / HZ30E1. Shut off gas and electrical supply, allow unit to cool to room temperature.2. Remove fl ush glass door (see unit manual).3. Carefully remove the logs from the packaging and unwrap them.The logs are fragile, handle with care -never force into position.4. Ensure glass crystals are installed on the burner.HZ33CE = 4lbs HZ30E=1lbHZ33CE INSTALL INSTRUCTIONS:5. HZ33CE only- Install log bracket onto left side of burner with 1 screwas shown below.HZ33CE - installbracket, left side6. Install log clip to lip on burner tray - position 9-1/2" from the left edgeof the burner tray to the centre of clip.7. Install Rear Log (1), seat on log clip and rest on left log bracket.Right side of log should sit fl ush with the outside edge of the pilot hood.8. Place Log 5 on the glass crystals on the left side.HZ33CE Log ClipHZ33CE Log BracketLog 1 in position Log 1 end of Log fl ushwith edge of pilot hood112 3459-1/2"519. Place Log 4 on the glass on the right side in location shown below.HZ33CE shown - Logs 1,4 and 5 in position.HZ33CE shown - Logs 1 and 5 in position.451HZ33CE/HZ30EHZ33CE/HZ30E - LOG INSTALLATIONOPTIONAL LOG SET INSTALLATION