14 | Regency Horizon HZ54E-10 Gas Fireplace|14 installationNailing StripsShipping brackets -remove after shipped.nailinG stripsThe nailing strips come attached to the unit. There is 1 plate on each side,that can be folded out as required. The side nailing strips are secured to theframing.unit asseMBlYprior toinstallationThe Top Standoff/ Nailing Strip, side nailing strips and standoffs must becorrectly positioned and attached to the unit before sliding the unit into position.standoff asseMBlYThe top, side and rear standoffs are shipped in a flat position and must befolded into shape and attached - see diagram 1.1) Remove the standoffs from the unit.2) Take each standoff and bend into the correct shape. Bend up at the bendlines until the screw holes in the standoff and the pre-punched screw holeson the unit line up.VentinG introductionThe HZ54E uses the "balanced flue" technology Co Axial system. Theinner liner vents products of combustion to the outside while the outer linerdraws outside combustion air into the combustion chamber thereby eliminatingthe need to use heated room air for combustion and losing warm room airup the chimney.Note: These flue pipes must not be connected to any other appliance.The gas appliance and vent system must be vented directly to the outside ofthe building, and never be attached to a chimney serving a separate solid fuelor gas burning appliance. each direct vent gas appliance must use it's ownseparate vent system. Common vent systems are prohibited.iMportant noteFraming depth measurement is noted with theside nailing strips set as far forward on thefirebox as possible. The nailing strips can beadjusted back up to 3-1/8” to allow for varyingthicknesses in non-combustible material & wallfinishes.Remove screws torelease standoffsStandoffnailing StripsStandoffDiagram 1Diagram 2Diagram 3StandoffStandoff