Regency Horizon HZ54E Gas Fireplace 33INSTALLATIONAn optional AC power adaptor may be installed as a constant power source for the SureFire system.NOTE: AC power adaptor is not required when using GTMF RemoteIMPORTANT: Recommend removing the 4-AA batteries in the SureFire receiver.This will avoid battery leakage and power drainage. 4-AA Battery pack may be re-installed into receiver during power outages.NOTE: For all Gas Fireplaces 120 volt power must be brought to the receptacle box inside the ERWWRPRIWKH¿UHER[(provided with the unit).All Freestanding Gas Stoves & Gas Inserts will need a receptacle box located outside / near the unitso that the AC Power Adaptor can be plugged in.INSTALL AC ADAPTOR WITH SUREFIRE WALL SWITCH ONLY - (WITHOUT REMOTE)INSTALL AC ADAPTOR WITH SUREFIRE PROFLAME GT / GTM REMOTE1) Locate “DC Supply” tag on wire harness. For location in unitsee remote installation page in owners manual.919-063 03/04/20132) Connect the male end from AC adaptor to the female endtagged “DC Supply” on wiring harness in unit.2) Locate FCM - COM connector on the Remote wire harness -see manual for location in unit.3) Plug in wire adaptor to FCM - COM connector - be careful notWRGDPDJHHQGV7KLVRQO\¿WVRQHZD\'R1RW)RUFHLQZURQJZD\3) Plug AC adaptor into 120V wall outlet (or into 120V receptacle ifLQVWDOOHGLQVLGHWKHJDV¿UHSODFH¿UHER[ 4) Neatly tuck any loose AC Power Adaptor wires neatly underneath /inside the appliance.Note: (QVXUHWKDWZLUHVGRQRWWRXFKWKHXQGHUVLGHRIWKH¿UHER[(keep wires away from the heat as much as possible).FCM - COMAC adaptorwire adaptor1) Connect the male end of the AC adaptor to the female end of thewire adaptor (supplied with AC adaptor) together as shown .AC adaptorWire adaptorFCM - COM4) Plug AC adaptor into 120V wall outlet (or into 120V receptacle ifLQVWDOOHGLQVLGHWKHJDV¿UHSODFH¿UHER[ 5) Neatly tuck any loose AC Power Adaptor wires neatly underneath /inside the appliance.Note: (QVXUHWKDWZLUHVGRQRWWRXFKWKHXQGHUVLGHRIWKH¿UHER[(keep wires away from the heat as much as possible).This method also applies for models, HZ30E - HZ40E - L390E - HZI390E1AC POWER ADAPTOR INSTALLATION (FOR SUREFIRE SYSTEMS)