Regency P33CE-NG Owners & Installation Manual

Contents

Regency P33CE-NG Owners & Installation Manual Manual pdf 47 page image

P33CE Direct Vent Gas Fireplace 47INSTALLATION10. Secure fan by pushing fan down onto mounting pins located on fl oor ofunit. Take care not to damage the insulation on the fan base. Ensurethat the fan blades do not rub against the valve tubing. Diagram6.Diagram 9Diagram 8Diagram 10Fan Control BoxControl Mounting PlateDiagram 11Diagram 1217. Secure the fan wires and power cord by attaching one of the adhe-sive backed wire holder clips (Part #910-199) to the Fireplace base.Use the second clip to bundle up the wires approximately 4" from thecontrol box. Ensure that there is no interference with the wires whenthe faceplate and trim are installed and that no wires will touch the hotmetal surfaces or sharp edges.18. Plug the fan power cord into the rear end of the receptacle box toprovide the maximum clearance.TO REMOVE THE FAN1. Shut the power off.2. Reverse the above instructions.Note: The bearings are lubricated for life. Do not lubricate them.Make sure you vacuum the fan area on a regular basis.IMPORTANT:These fans collect a lot of dust from within your home. Ensure youmaintain these fan motors on a regular basis by vacuuming out thefan blades and housing using a soft brush nozzle.15. Position the control plate assembly on the left hand side of the fi rebox.Diagram 1116. Secure the control plate assembly with one (1) screw as shown inDiagram 12.14. Attach the fan control box to the Control Plate. (Diagrams 9 & 10.13. Remove lower base cover by removing 2 screws and lifting out (Diagram 8).Diagram 5Diagram 6Diagram 79. Manoeuvre fan into valve tray opening at base of fi rebox.11. Connect fan ground cable to ground lug. Refer to wiring diagram.12. Slide the thermodisc/cover assembly into the bracket clip on theunderside of the firebox (Diagram 7).Check that no wires will touch the hot surfaces.8. Remove the 12 screws securing the valve tray assembly in place(Diagram 4) and then lift the entire assembly out.Diagram 4 Valve Tray Assembly