Regency P36D-NG2 Owners & Installation

Regency P36D-NG2 Owners & Installation Manual pdf 21 page image

Regency ® P36D Gas Log Fireplace 21OPTIONALBRICK PANELS1) Undo the bottom 2 door latches and openand remove glass door. Remove logs.Note: The logs must not be in the unit.2) Insert the back brick panel first by carefullyslipping it between the back wall of thefirebox and the rear log bracket.4) Light the pilot and turn the valve to "ON"position.5) The pressure check should be carried outwith the unit burning and the setting shouldbe within the limits specified on the safetylabel.6) When finished reading manometer, turnoff the gas valve, disconnect the hose andtighten the screw (clockwise) with a 1/8" flatscrewdriver. Note: Screw should be snug,but do not over tighten.S.I.T. VALVE DESCRIPTION1) Gas on/off knob2) Manual high/low adjustment3) Pilot Adjustment4) Thermocouple Connection - option5) Outlet Pressure Tap6) Inlet Pressure Tap7) Pilot Outlet8) Main Gas Outlet9) Alternative TC Connection Point3) Put the side panels in next. Slide them infrom the front and push them flat up againstthe wall. Be very careful not to scratch themon the firebox hardware.4) Install the 2 brick retaining clips, one oneach side.INSTALLATIONLOG SETINSTALLATIONRead the instructions below carefully andrefer to the diagrams. If logs are brokendo not use the unit until they are replaced.Broken logs can interfere with the pilotoperation.The gas log kit (Part # 780-930) contains thefollowing pieces:a) 02-75 Rear Logb) 02-55 Middle Left Logc) 02-50 Front Left Logd) 02-53 Center Left Loge) 02-51 Front Bottom Logf) 02-54 Center Right Logg) 02-52 Middle Right Logh) EmbersNOTE: If you will be installing the optionalBrick Panels, install the Brick Panelsprior to installing the logs.1) Carefully remove the logs from the box andunwrap them. The logs are fragile, handlewith care - do not force into position.2) Sprinkle the vermiculite all over the top ofthe base brick panel.3) Place the Log 02-75 on the rear log supportpins with the flat side to the back.The "02" refer numbers (i.e. 02-75) aremolded into the rear of each log.02-7502-7502-55 02-5202-50 02-53 02-51 02-54