Regency PG36NG3-R Manual

Regency ® PG36-3 Gas Log Fireplace30MAINTENANCEGOLD Or BRASSLOUVRES & TRIMThe 24 carat gold plated or brass finish on thetrim requires little maintenance, and need onlybe cleaned with a damp cloth. DO NOT useabrasive materials or chemical cleaners, asthey may harm the finish and void the warranty.Clean any fingerprints off before turning theunit on. If the top louvres start to discolour,check the door gasket seal and replace ifnecessary.LOG REPLACEMENTThe unit should never be used with brokenlogs. Turn off the gas valve and allow theunit to cool before opening door and carefullyremove the logs. If for any reason a log shouldneed replacement, you must use the properreplacement log. The position of these logsmust be as shown in the diagrams under LogInstallation.Note: Improper positioning of logs maycreate carbon build-up and willseverely alter the unit's performancewhich is not covered underwarranty.GLASS GASKETIf the glass gasket requires replacement use5/8" flat glass gasket for the Bay Front (Part# 936-243) and a tadpole glass gasket for theFlush Front (Part # 936-155).DOOR GLASSYour Regency ® fireplace is supplied with hightemperature, 5 mm Neoceram ceramic glass thatwill withstand the highest heat that your unit willproduce. If your glass requires cleaning, werecommend using an approved glass cleaneravailable at all authorized dealers. Do not useabrasive materials. Do not clean the glasswhen hot.In the event that you break your glass by impact,purchase your replacement from an authorizedRegency ® dealer only, and follow our step-by-step instructions for replacement.WARNING: Do not operate theappliance with the glass panelsremoved, cracked or broken.Replacement of the glass panelsshould be done by a licensed orqualified service person.Caution: Wear gloves when remov-ing damaged or broken glass.Flush Glass ReplacementRemove the flush door front (as per instructionsin the "Standard Flush Door" section). Removethe 4 glass clips from each corner. Slide in thenew replacement glass. Push the 4 glass clipsback onto the frame. The glass must havegasketing around it.Bay Glass Replacement1) Remove the door from the unit and placeon a soft surface to prevent scratching.2) Remove the nuts holding the glass clips inplace and remove.3) Replace the glass. The glass must havegasketing around it.5) Reverse the previous steps, replace theglass clips and fasten with the nuts but do notover tighten, as this can break the glass.6) Replace door on the Gas log fireplace andcheck the seal.