|
ETHERLINK II - Repeater ManualPage 74 of 1064.6.5.6 commandThe 16/32> command sets the number of levels in the line code. The following optionsare possible – 16, 32.For modems with one xDSL channel, the following command is used:CO_01_CM>PAM 16Compatibility with the Etherlink modem is achieved by setting BASERATE in the range from 3 to32 and by setting the line coding equal to PAM 16.The command activates the automatic detection of PAM and Annex.4.6.5.7 commandThe command enables the transmission standard: G.991.2 ANNEX A orG.991.2 ANNEX B, where N is the number of the interface.The automatically selects the transmission standard.Note: If devices use different transmission standards, synchronization will not be establishedbetween them.4.6.5.8 commandThe command is used to set user and administrator passwords.RR_01_CM>PASSWORD USEREnter password:Confirm password:RR_01_CM>Only the administrator can perform this command. The password length is no more than 11symbols. The password can contain Latin letters and digits.Note: It is also possible to set an empty password (in this case, the password is not requestedwhile opening the telnet session). This command sets the password only to access thedevice over the telnet protocol. When managing the devices via the RS-232 interface,the password is not requested.4.6.5.9 commandThe command is used to enter identification number of the device (N is the textcontaining no more that 12 symbols). This ID will be displayed atop the main menu. Ifthe parameter is not written, the device ID will be empty.4.6.5.10 commandThe command sets the default operation mode, where N is the mode number(there are four default operation modes).Parameters:0: MODE AUTO, LINECODING AUTO, BASERATE AUTO, ANNEX A / B, WAN ---1: MODE AUTO, LINECODING PAM32, BASERATE 89, ANNEX B, WAN ---
|
