Saaa ALTEA 3-BUS User Manual

Contents

Table Of Contents
Getting Started
The IR receiver / LCD display
Displayed at the start
First startup
Plug & Play procedure
Blanking
Adding a product to an existing configuration
Alarm management
Repair mode
Alarm default BUS
Stop the Altea 3 (not recommended)
Adding a distributor
Key usage
Associating a RED key to a Altea 3 (when the blue key is allready allocated)
Associating blue, green or yellow keys to a Altea 3
Deleting a key from the Altea 3
Special procedure: what to do if I have lost my red key
Digital Signage option

Saaa ALTEA 3-BUS User Manual Manual pdf 13 page image

page: 13USER GUIDEUpdate : 7/2/110Z NOT FR 0906Vitrea9.0/ Repair modeA short press on a blue or green key while there is no alarm will enter the repair mode. If the Altea 3 findsproblems that require your attention it will indicate them through the LCD display:Fix the designated problem (generally by properly re-sticking the sensor, using a new adhesive) . The Altea3 will then move to the next detected problem. When all problems are solved, the display shows the slowlyblinking dot again.Graph009REPAIR MODEThe LCD display toggles between the numberof the position where a problem wasdetected and the type of problemThe control unit restartsits operation normallyFix the problem(s)Briefly pressthe remotecontrol buttonBriefly pressthe remotecontrol buttonBlue remote controlBlue remote control

/ 24

This manual is suitable for:

ALTEA 3-BUS ALTEA 3-BUS-DS

manualsdatabase

Your AI-powered manual search engine