Saaa ALTEA 3-BUS User Manual
                        | |
Contents
| 
page: 7USER GUIDEUpdate : 7/2/110Z NOT FR 0906Vitrea3.0/ First startup.1 - Opun the battery compartment2 - Insert 3 standard AA batteries into the control unit3 - Close the battery compartment.4 - Connect the IR receiver / display to the control unitAt this stage, you may want to already connect up to 8 sensors to the control unit or you may wantto power it up with no sensors and add them one by one later while the control unit is ON. Wha-tever you choose, the control unit will behave the same at the first power up:5 - Connect the power supply.6 - The display will show the clockwise revolving digits7 - ASSOCIATE at least one blue key to the control unitOnce this is done, the Altea 3 will start operating and the display will show the slowly blinking dot.8 - Install mode: the Altea 3 will then browse through its 8 inputs, starting from input1. When it finds a sensor with every possible protection properly applied (ie both themain and nano sensors properly stuck for the Altea 3, or the main, the nano and thepower supply sensors for the Altea 3 Pro) it just skips to the next input (if all 8 inputshave all sensors and all protections properly applied, then the control unit will juststart its operation).Graph0041 2 3Graph0054 5Graph005b> the LCD displaydigits are sequentiallylit clockwise> the LCD displaydigits are sequentiallylit clockwiseOnly the first timethe system is poweredBrifly pressthe remotecontrol buttonBrifly pressthe remotecontrol buttonBlue remote controlBlue remote control |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine