R5 SUPREME - Navigation System MkIISTART UP7000 118-383, B1 Page 387 START UPWhen the physical and electrical installation of the system is complete, the R5 SUPREMENavigation System needs to be configured. This chapter describes what the installer is requiredto do before the R5 SUPREME Navigation System is ready to operate.7.1 Configuration WizardThe first time the R5 SUPREME CDU is started, a configuration wizard will be shown. Thiswizard is a helpful guide to configure the basic functionality of the R5 SUPREME System.The following sections describe the different steps in the configuration wizard.System SetupThe R5 SUPREME CDU can be used in a standalone AIS system, standalone Navigationsystem, Combined AIS and Navigation system or be used as a slave display to an existingR5 Navigation System. The Navigation system can be configured into two different types,either GNSS or DGNSS, and is compatible with both the R5- and the R4 Navigation sensor.It is up to the user to specify which equipment is connected to the R5 SUPREME CDU.Control check which sort of sensor you have before selecting system type!Navigation System (DGNSS) requires either R4 DGNSS Navigation Sensor (7000 109-180)or R5 DGNSS Navigation Sensor (7000 118-771)Navigation System (GNSS) requires either R4 GNSS Navigation Sensor (7000 109-181) orR5 GNSS Navigation Sensor (7000 118-770)Figure 16 – System Setup
