Saeco 10003176 Operating Instructions Manual

Contents

Saeco 10003176 Operating Instructions Manual Manual pdf 9 page image

9EnglishINSTALLATIONAlways use only fresh, non-sparkling waterto fill the tank (7). Hot water or any otherliquid may damage the tank and/or the machine.Do not turn on the machine without water: makesure there is enough water in the tank.• (Fig.24) - Remove the cover (2) and add the coffeebeans.Always add only coffee beans in the coffeebean hopper (1). Ground coffee, instantcoffee or any other object may damage themachine.• Replace the cover (2) on the coffee bean hopper (1).• Insert the plug into a suitable socket.4.3 Circuit PrimingIn the beginning, after dispensing steam or when thewater tank is empty, the machine’s water circuit mustbe primed.• The power button (5) is switched to -0-. Press but-ton (5) to turn on the machine. The light (23) on thecontrol panel will turn on.• (Fig.26) - Place a container beneath the steamwand (Pannarello)(12) to prime the circuit. Turn theknob (14) counter-clockwise and wait until waterflows steadily out of the steam wand (Pannarello).Turn the knob (14) clockwise to stop water dispens-ing.• The circuit is now primed.4.4 Using the machine for thefirst time or after a period ofinactivityThis simple operation ensures optimum brewing andmust be performed:- At first start-up;- When the machine remains inactive for a long time(more than 2 weeks).Dispensed water must be emptied into anadequate drain. It is not suitable for fooduse. If the container fills up, stop dispensing waterduring the cycle and empty it before resumingthe operation.1 (Fig.25) - Make sure that the water tank (7) is filledwith drinking water; otherwise, empty the tank andreplace with fresh water.2 Place a container beneath the steam wand(Pannarello) (12) and turn the knob (14) counter-clockwise.3 After 30 seconds (or when the container is full)stop dispensing water by turning the knob (14)clockwise.4 Wait about 60 seconds. Repeat the operations fromstep 2 until emptying out the tank.5 (Fig.25) - Once run out of water, fill the tank again(7) and carry out a new cycle from step (2) as previ-ously mentioned.6 Once emptied the tank for the second time, fill itagain with water; the machine is now ready foruse.Note: if required, prime the circuit.• To brew coffee, dispense hot water or steam, andfor a proper use of the machine, carefully follow theinstructions provided.