Saeco Incanto HD8911 Instruction Manual

Also see for Incanto HD8911: Manual User manual User manual User manual Manual

15ENGLISH> Press the MENU button and scroll the menu to go to the descaling function.> Press the OK button to select the descaling function.> Press the OK button to launch the descaling cycle. The machine starts dispensing thedescaling solution at intervals. The bar shows the cycle progress status.The cycle can be paused by pressing the ESC button and restarted by pressing the OKbutton. This makes it possible for the user to empty the container or leave for a while.Let the water be discharged until the tank is empty.> Remove the water tank and rinse it.> Fill it with fresh water to the MAX level and return it to its proper place.> Remove and empty the container.Repeat the entire sequence of operations described in the “Preparation phase” aboveand proceed with the “Rinsing phase”.Rinsing phase> Press the OK button to launch the rinse cycle.The cycle can be paused by pressing the ESC button and restarted by pressing the OKbutton. This makes it possible for the user to empty the container or leave for a while.If the water tank was not filled to the MAX level, the machine might require anotherrinse cycle. In this case, fill the water tank to the MAX level, put it back in the machineand repeat the “Rinsing phase”.Let the product be dispensed until the process stops automatically.> Press the OK button to exit the descaling cycle.The machine goes through the heatingand automatic rinse process.> Remove and empty the container with dispensed water.Perform the “7.4.2 Weekly cleaning of the milk frother components” procedure.Perform the “7.2.1 Weekly brew group cleaning cycle” procedure.> You can now install the AquaClean water filter if used: refer to the“10.2 AquaCleanwater filter” chapter.At the end, the machine goes back to the main menu.Place the milk frother back on the steam wand.It is recommended to perform a “5.2.3 Manual rinse cycle”.7.5.1 Interruption of the descaling cycle> Once the descaling cycle has started, you must complete it till the very end withoutturning off the machine.> In case you get stuck during the cycle or in case of power failure or accidentaldisconnection of the power cord, you can exit by pressing the STAND-BY button.> If this occurs, empty and rinse carefully the water tank, then fill it up to the CALCCLEAN level. Follow the instructions provided in the “5.2.3 Manual rinse cycle” chapterbefore brewing any product. If the cycle was not completed, the machine will requireanother descaling cycle to be performed at your earliest convenience.8. Default settings8.1 List of default settingsDisplay Setting Value DescriptionCOFFEETEMPMAXMEDMINCoffeetemperature average Coffee brewing temperature setting.STARTCALCCLEANFILTERSTARTCALCCLEANCALCCLEANreddisplayMAXCALCCLEANMAXCCALCCLEANCALC CLEANSTARTCALCCLEANFILTERSTARTCALCCLEANIncanto_CMF_EN-IT-DE_Rev01.indb 15 27/03/15 09:55