31errOr cODesGUIDE MESSAGE THAT APPEARS HOW TO REMOVE THE MESSAGEout of service (xx)restart to fix…(XX) identifi es an error code.Turn off and after 30 secondsturn the machine on again to restore normal operation.Ifthe problem persists, call Saeco or an authorized servicecenter and give the code (xx) shown on the display.close coffee bean lid Close the coffee bean hopper lid to be able to make abeverage.fill container wth coffee Put coffee beans into the bean hopper.insert the brew group Insert the brew group in its place (see page 30).insert grounds drawer Insert the dregdrawer.empty grounds This preliminary warning does not stop the machine fromfunctioning. Proceed until the next message appears.empty grounds drawer Remove the dregdrawer and dispose of the used coffeegrounds (see page 29, steps 1 and 2.).note: the dregdrawer must be emptied only when themachine requires it and when the machine is turnedon. if you empty the drawer with the machine turnedoff it will not reset the count of cycles.close door In order for the machine to operate, the side service doormust be closed.fill the water tank. The tank must be removed and refilled with fresh drinkingwater.empty the drip tray Open the side service door and empty the drip tray locatedunder the brew group.Warning: WheneVer this Message aPPears, Besure tO eMPtY the DregDraWer as Well.change filter The water fi lter must be replaced in the following cases:1. 60 liters of water have been dispensed;2. 60 days have passed since its installation;3. 20 days have passed after the machine’s last use.Note: this message only appears when the filter alarmfunction has been set to “on” (see page 22, menu 2.4).carafe missingmilk island missingThe steam knob has been turned to the position andeither the Milk Island has not been installed or the carafeis not positioned correctly. Install the Milk Island or positionthe carafe correctly.Otherwise, turn the knob until it is in the rest position ( ).descale A descaling cycle must be performed on the machine’sinternal circuits (see page 25).stand-by… Press the button.