Chapter 5: Starting up the systemPowering the system 615555Starting up the system5.2 Powering the system5.2.1 Switching the terminal onTo switch on the terminal, usethe Power switch in theconnector panel It normallytakes one or two seconds for theterminal to switch on.5.2.2 Switching the terminal offTo switch off the terminal, change the position of the Power switch again.5.2.3 Remote on/offAlternatively, you may use the Remote on/off function. In this case, leave thepower switch in the On position and switch off the terminal remotely using aswitch or similar connected to the Remote on/off pins in the DC powerinterface. For further information, see Remote on/off on page 43.Caution! When the system is powered on, stay clear of theantenna! The antenna emits radio frequency energy, notonly when the system is used. Always keep a minimumdistance of 1.3 m from the SAILOR 500 FleetBroadbandantenna and 0.6 m from the SAILOR 250 FleetBroadbandantenna.Note Wait at least 5 seconds after power off, before trying to power on thesystem again.
