UAIS DEBEG 3400, Electronics UnitED3047G142 / 08 (2004-06)Technical Manual5 Setting-to-Work/Configuration5.4 Testingt_ue_e05.fm / 21.06.04505.3.1 Configuration with DCU DEBEG 3401It is necessary to configure the DCU. For information in detail see the Technical Manual of the DCUDEBEG 3401.5.3.2 Configuration with RADARPILOT/CHARTRADAR/MULTIPILOT 1000 - NACOS xx-4 SystemsIt is necessary to configure the radar and the interfaces. For information in detail see the TechnicalManual of the RADARPILOT/CHARTRADAR 1000 and MULTIPILOT 1000.5.3.3 Configuration with CHARTPILOT 93xx in NACOS xx-3 SystemsIt is necessary to configure the CHARTPILOT 93xx and the interfaces of the Ship’s Interface. For infor-mation in detail see the Technical Manual of the CHARTPILOT 93xx.5.3.4 Configuration with Radar 9xxxIt is necessary to configure the interfaces of the Ship’s Interface. For information in detail see the ServiceManual of the Radar 9xxx Electronics Unit.5.4 TestingThe Electronics Unit has neither operating elements nor a display. Correct functioning cannot be madevisible directly.To test the interfaces of the ship’s sensor inputs and the interface to the display unit (which can be theRADARPILOT 1000, CHARTPILOT 9330, MULTIPILOT 1000 or the Display and Control Unit DEBEG3401), set the system in operation and select the own ship’s symbol. If the own ship AIS data aredisplayed, the interfaces are working properly.The VHF Transceiver can only be tested if a second AIS system is within the range of the Transceiver.The signals of this AIS must be received and this second AIS must receive the signals of your own AIS.The pilot port can be tested by means of a PC with a terminal software, a RS422/RS232 converter andcable with the suitable connector. The connector consists of the following components which can bepurchased from most specialist dealers:- Plug assembly, AMP part No. 206485-1- Socket contact, AMP part No. 66569-3- Cable clamp kit, AMP part No. 182928-1
