Salicru SLC TWIN RT series User Manual

Contents

Salicru SLC TWIN RT series User Manual Manual pdf 20 page image

20"F""H""J""G""K""K"Fig. 8. Model in vertical -tower type- assembling with ex-tended back up time (battery module).Ŗ Regarding the connections of the UPS with the batterymodule in models up to 6 kVA, make the following steps, butreading section 4.3.4 previously: Connect the supplied earth joint cable "F", between theUPS and battery module. Remove the beautiful front cover of the equipment andbattery module, as it is described in section 4.2.5.2. Take the extensible cable with connector "H" of the bat-tery module and connect it with the "G" connector of theequipment.To connect it with other battery modules, there is the "J"connector. Take the extensible cable with "H" connectorof the beside battery module and connect it to the "J" con-nector of the previous one. Repeat the same steps for ahigh quantity of modules. In the side of each front cover, there are the "K" trims ashole to go the cables through it with the battery modules.Break the needed trims to pass the connection bus. Put the beautiful front cover back of the equipment andbattery module, as it is stated in section 4.2.5.2.Ŗ For 8 and 10 kVA UPSs with the battery module, proceed asfollows, but reading section 4.3.4 previously (see figure 11): Connect the supplied earth joint cable , between the UPSand battery module. To connect the battery module with the equipment, thereis a connector on the rear side of both units. Insert theaerial connector from battery module into the connectorof the equipment. Battery module has base connector, foreseen to connectthe aerial connector from another module .4.2.5.5. 19" rack cabinet mounting.Ŗ All models can be installed in a 19" rack cabinet, attendingthe height of each model: Models up to 3 kVA, 2 units height. Models from 4 and 6 kVA,3 units height. Models of 8 and 10 kVA, 5 units height."A""C""B"Fig. 9. 19" rack cabinet assembling.USER MANUAL