Salus Connected Wireless System Manual
                                                         | |
Contents
|
3-4Step 1. Locate the Sensor and Magnet MAKE SURE that the square corners of the Sensor and the Magnetface each other If the SALUS recommended option (Figure A) is not possible, the sensor can be mounted onthe door or window with the magnet mounted on the casing If necessary, the components can be mountedon different levels (Figure B) or different orientations (Figure C) Because of the narrow gap between thewindow and the screen on a casement window, the sensor can be mounted inside of the screen (Figure D)The double-sided tape, included with the SS882ZB Door/Window Sensor may be used in cases wherewater/vapor seals or barriers may cause an issue. For UL certified installation, screws must be used.Module 2 – Wireless AccessoriesSS882ZB Door/Window SensorSection 3Installation InstructionsThe key criteria for locating the magnet in relation to the sensor are:- The magnet should be within 1 inch of the center of the square cornered edge of the sensor- The magnet should be along the same axis as the straight cornered edgeSALUS recommends locating the Window/Door Sensor on the window or door casing on the handleside. The Magnet should be mounted on the window or door as close as possible to the Sensor. To be ULcompliant, the Sensor and Magnet must be mounted using the screws.Figure A Figure B Figure C Figure DStep 2. Attach the Sensorand Magnet mounting platesin the desired locationsNOTE: If the tamper switch is notengaged, an “Issues” indicator will appearon the dashboard and the Sensor icon willturn red Pressing “Issues” will show thatthe “Sensor is Tampered”Step 3. Snap the sensoronto the mounting plateand verify that the tamperswitch is engaged |
Related manuals for Salus Connected Wireless System
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine