English - 1Display ModesBoth screen position and size will vary depending on the type of PC monitor and its resolution. The resolutions in the table arerecommended.D-Sub and HDMI/DVI InputMode Resolution Horizontal Frequency(KHz)Vertical Frequency(Hz)Pixel Clock Frequency(MHz)Sync Polarity(H / V)IBM 640 x 350 31.469 70.086 25.175 +/-720 x 400 31.469 70.087 28.322 -/+MAC 640 x 480 35.000 66.667 30.240 -/-832 x 624 49.726 74.551 57.284 -/-VESA CVT 720 x 576 35.910 59.950 32.750 -/+1280 x 720 44.772 59.855 74.500 -/+1280 x 720 56.456 74.777 95.750 -/+VESA DMT 640 x 480 31.469 59.940 25.175 -/-640 x 480 37.500 75.000 31.500 -/-640 x 480 37.861 72.809 31.500 -/-800 x 600 37.879 60.317 40.000 +/+800 x 600 46.875 75.000 49.500 +/+800 x 600 48.077 72.188 50.000 +/+1024 x 768 48.363 60.004 65.000 -/-1024 x 768 56.476 70.069 75.000 -/-1024 x 768 60.023 75.029 78.750 +/+1360 x 768 47.712 60.015 85.500 +/+VESA GTF 1280 x 720 52.500 70.000 89.040 -/+When using an HDMI/DVI cable connection, you must use the HDMI (DVI) jack.The interlace mode is not supported.The set might operate abnormally if a non-standard video format is selected.Separate and Composite modes are supported. SOG is not supported.Setting up the TV with your PCPreset: Press the SOURCE button to select PC mode.Auto AdjustmentAuto Adjustment allows the PC screen of set to self-adjust to the incoming PC video signal.The values of fine, coarse and position are adjusted automatically.This function does not work in DVI-HDMI mode.Press the TOOLS button to display the Tools menu. You can also set the Auto Adjustmentby selecting Tools → Auto Adjustment.ScreenCoarse / FineThe purpose of picture quality adjustment is to remove or reduce picture noise. If the noise isnot removed by Fine-tuning alone, then adjust the frequency as best as possible (Coarse) and Fine-tune again. After the noise hasbeen reduced, readjust the picture so that it is aligned on the centre of screen.PC PositionAdjust the PC’s screen positioning if it does not fit the TV screen. Press the ▲ or ▼ button to adjusting the Vertical-Position. Pressthe ◄ or ► button to adjust the Horizontal-Position.Image ResetYou can replace all image settings with the factory default values.NNNN¦N❑NT❑Brightness: : 45Sharpness : 50Auto Adjustment ►ScreenAdvanced SettingsPicture OptionsPicture ResetPicture
