English - After you have made this connection, set the A/B switch to the "A" position for normal viewing. Set the A/B switch to the "B" position toview scrambled channels. (When you set the A/B switch to "B", you will need to tune your TV to the cable box’s output channel, which isusually channel 3 or 4.)Connecting to a Cable box that Descrambles Some ChannelsIf your cable box descrambles only some channels (such as premium channels), follow the instructions below. You will need a two-way splitter, an RF (A/B) switch and four lengths of RF cable. (These items are available at most electronics stores.)1. Find and disconnect the cable that isconnected to the ANT IN terminal on yourcable box.This terminal might be labeled "ANT IN","VHF IN" or simply, "IN".2. Connect this cable to a two-way splitter.3. Connect an RF cable between the OUTPUTterminal on the splitter and the IN terminalon the cable box.4. Connect an RF cable between theANT OUT terminal on the cable box andthe B–IN terminal on the RF(A/B) switch.5. Connect another cable between the otherOUT terminal on the splitter and the A–INterminal on the RF (A/B) switch.6. Connect the last RF cable between theOUT terminal on the RF (A/B) switch andthe ANT IN terminal on the rear of the TV.SplitterIncomingcableSplitterCable boxIncomingcableSplitterCable boxrf (a/b)SwitchIncomingcableant InSplitterCable boxIncomingcablerf (a/b)SwitchSplitterCable boxIncomingcable tV rearrf (a/b)Switchant InConnecting Cable tVTo connect to a cable TV system, follow the instructions below.Cable without a Cable box1. Plug the incoming cable into the ANT IN terminal on the back of the TV.Because this TV is cable-ready, you do not need a cable box to view unscrambled cable channels.Connecting to a Cable box that Descrambles all Channels1. Find the cable that is connected to the ANT OUT terminal on your cable box.This terminal might be labeled "ANT OUT", "VHF OUT" or simply, "OUT".2. Connect the other end of this cable to the ANT IN terminal on the back of the TV.ant outant InANT INANT IN
