English - 70Connecting WPS (Wi-Fi Protected Setup)❑If Security Key is already set : In access point list, select WPS.You can selectN PBC, PIN, Security Key.Connecting by using• PBC: Select a PBC (Push Button Coniguration). Press thePBC button on the AP (access point) within 2minutes, and wait for connection.Connecting by using• PIN: Select a PIN (Personal Identiication Number).The message showing the PIN Code is displayed. Input the PIN Code at APNdevice within 2minutes. Select OK and wait for connection.Try again if connecting operation doesn’t workNWhen the connection is not established although tried again, reset the accessNpoint. Please refer to a manual of each access point.Connecting by using• Security Key: When selecting Security Key, the inputwindow is displayed. Input the security key and press Blue button.Try again if connecting operation doesn’t work.NIf Security Key is not set : When the security setting of AP that supports WPSis NONE, you can select PBC, PIN, None Security. None Security is capableof connecting to AP directly without using WPS function.Process ofN PBC, PIN is same as above. Refer to if Security Key is already set.Try again if connecting operation doesn’t work.NAd-hoc : You can connect to a mobile device without an access point through the‘Samsung Wireless LAN Adapter’ by using a peer to peer network.How to connect to new Ad-hoc•1. Choose Select a network, then a device list is displayed.2. While in the device list, press the Blue button on the remote or select Ad-hoc.The messageN The existing network system may have limited functionality. Do you want to change the networkconnection? is displayed.3. Input the generated Network Name(SSID) and Security Key into the device you want to connect.How to connect an existing Ad-hoc device•1. Choose Select a network, the device list is displayed.2. Select the device you want in the Device list.3. If security key was applied, input the security key again.If network doesn’t operate normally, please check theN Network Name(SSID) and Security Key again.If the Security Key is incorrect, it may be the reason for the malfunction.*The existing network system may have limitedfunctionality. Do you want to change the networkconnection?NoYes** ***Wireless Network SetupSelect a networkn Move E Enter R ReturnSearchAd-hocAP_1AP_2AP_3AP_4 *PBCPINSecurity Key3/9*Press the PBC button on the access point.Access Point Name : AP_3Cancel*Press OK After input TV’s Pincode in the accesspoint’s setup.Access Point Name : AP_3PIN Code : 12345678CancelOK** ***Wireless Network SetupSelect a networkn Move E Enter R ReturnSearchAd-hocAP_1AP_2AP_3AP_4 *PBCPINSecurity Key3/9* **** ** *Wireless Network SetupSecurity Keyn Move Number E Enter R Return_A B C D E F GH I J K L M NO P Q R S T UV W X Y Z0~9 NumberLowercaseDeleteDoneBN68-850_Eng.indb 70 2009-06-18 3:56:06
