English - 20Installing Smart View 2.0 a Near Field Communications(NFC) DeviceSmart View 2.0 is a cross-platform multi-screen app that enables you to load the TV screen on an NFCcompatible device, share multimedia contents between two devices, and control the TV remotely.To install Smart View 2.0, follow these easy steps:1. Activate NFC on the mobile device.‐ For more information, refer to the device's manual.2. Put the mobile device near the NFC logo on the battery cover of the Samsung Smart Control.‐ Make sure that the mobile device's display stays active during the process. If the display turns off, NFCcommunications will be disconnected.3. Smart View 2.0 automatically installs and then launches on the mobile device.‐ If your mobile device did not install Smart View 2.0, visit Google Play and install the app.Important Information• NFC comes only with Android v4.12 Jellybean or later.‐ NFC is enabled only on Android 4.12 Jellybean or higher mobile devices. The NFC tag is also required.For more information, refer to the mobile device's manual.‐ To enable NFC on mobile devices using operating systems earlier than Android 4.12 Jellybean,download the Samsung NFC Connection app from Google Play and install it on the device. The NFCtag is also required.• The connection may fail if the mobile device is not properly aligned with the NFC logo. If the "Empty tag"error appears on the mobile device, try again. Bring the mobile device close to the Samsung Smart Controland position it so that its NFC antenna faces the NFC logo on the Samsung Smart Control. Samsung SmartControl so that the NFC antenna faces the NFC logo.• The NFC antenna's position depends on the device model. Locate the NFC antenna before proceeding.• A thick cellular-phone case may interrupt the connection between the two devices.• The Certification Mark is a trademark or registered trademark of NFC Forum, Inc. in the United States andin other countries.