Samsung AQ09UGFN User & Installation Manual

Also see for AQ09T Series: User & installation manual User & installation manual

28Wall<20mmPlasticAnchorFixing the installation plate2. Fix the indoor unit.If you fix the indoor unit on a wall(1) Fix the installation plate to the wall giving attention to the weight of the indoor unit.If you fix the indoor unit on a window frame(1) Determine the positions of the wooden uprights to beattached to the window frame.(2) Attach the wooden uprights to the window frame givingattention to the weight of the indoor unit.(3) Attach the installation plate to the wooden upright usingtapping screws.If you fix the indoor unit on a gypsum board(1) Use stud finder to find out locations of the studs.(2) Fix the plate hanger on two studs.• If you mount the plate to a concrete wall using plastic anchors, make sure thatgaps between the wall and the plate, created by projected anchor, is less than20mm.• Search for other spots if there are less than two studs, or the distance between the studs are different from theplate hanger.• Fix the installation plate without inclining to one side.1. Extend the assembly cable if necessary.• Do not connect two or more different cables to extend the length.It may cause fire.• Make sure that a wall can withstand the weight of the product. If you install the product in a place where it is notstrong enough to withstand the product weight, the unit could fall and cause injury.Connecting the assembly cable When you install the unit, make first refrigerant connections and then electrical connections.Connect the air conditioner to grounding system before performing the electrical connection.If unit is uninstalled, first disconnect electrical cables, then refrigerant connections.If the outdoor unit is more than 5 meters away from the indoor unit, you must extend the cable.The maximum length of the cable is 15(09/12)/20(18/24) meters.• Connect the power cable to the auxiliary circuit breaker. If every pole fails to connect tothe power supply, it must be incorporated in a wire with a contact opening of ≥3mm.Model Power cable Interconnection cable Type GL09/12 3G, 1.0mm² H07RN-F 5G, 1.0mm² H07RN-F 20A18 3G, 1.5mm² H07RN-F 2G, 0.75mm² H05RN-F3G, 1.5mm² H07RN-F 25A24 3G, 2.5mm² H07RN-F 3G, 2.5mm² H07RN-F2G, 0.75mm² H05RN-FCable specificationConnecting the cableBoracay EUR_AQ09T&U@_IBIM_32447A_E.indd 28 2011-3-19 10:08:09