Samsung AR**MXWS Series Installation Manual

Contents

14EnglishInstallationWARNING• Connect the wires firmly so that wires cannot bepulled out easily. (If they are loose, it could causeburn-out of the wires.)Step 2.4 Optional: Extending thepower cable1 Prepare the following tools.Tools Spec ShapeCrimping pliers MH-14Connection sleeve(mm)20xØ7.0(HxOD)Insulation tape Width 18mmContraction tube(mm)50xØ8.0(LxOD)2 As shown in the figure, peel off the shields from therubber or wire of the power cable.• Peel off 20 mm of cable shields from thepreinstalled tube.CAUTION• For information about the power cablespecifications for indoor and outdoor units, refer tothe installation manual.• After peeling off cable wires from the preinstalledtube, insert a contraction tube.Power cablePre-installed tube for the power cable(Unit: mm)(Unit: mm)20 202020601201803 Insert both sides of core wire of the power cable intothe connection sleeve.• Method 1: Push the core wire into the sleeve fromboth sides.• Method 2: Twist the wire cores together and pushit into the sleeve.Connection sleeve Connection sleeveMethod 1 Method 24 Using a crimping tool, compress the two points andflip it over and compress another two points in thesame location.• The compression dimension should be 8.0.Compressiondimension• After compressing it, pull both sides of the wire tomake sure it is firmly pressed.Compress it 4 times.5 mmCompress it 4 times.5 mmMethod 1 Method 25 Wrap it with the insulation tape twice or more andposition your contraction tube in the middle of theinsulation tape.Three or more layers of insulation are required.Method 1 Method 2Insulation tape40 mm 35 mmInsulation tape6 Apply heat to the contraction tube to contract it.Contraction tube7 After tube contraction work is completed, wrap it withthe insulation tape to finish.Insulation tape