Samsung BN68-02711B-04 User Manual

Also see for LED 6400 series: User manual User manual E-manual Quick start guide E-manual

29English04 Advanced FeaturesNoticeThe picture may appear corrupted or have static for some channels when the TV is connected to the Samsung Wireless LANAdapter. In such a case, establish a connection using one of the following methods or connect the Samsung Wireless LANAdapter using a USB cable in a place that is not affected by radio interference.Method 1 Method 2Connect using the USB right angle adapter Connect via an extension cable✎ The Samsung Wireless LAN Adapter should be installed in aninterference-free area in order to avoid interference between theadapter and tuner.To connect the Samsung Wireless LAN Adapter using the USB right angleadapter, follow these steps:1. Connect the USB right angle adapter to the Samsung Wireless LANAdapter.2. Connect the other end of the right angle adapter to the USB 1 (HDD)port.To connect the Samsung Wireless LAN Adapter using an extensioncable, follow these steps:1. Connect the extension cable to the USB 1 (HDD) port.2. Connect the extension cable and Samsung Wireless LANAdapter.3. Attach the Samsung Wireless LAN Adapter to the back of the TVnear the top, using double-sided adhesive tape.Network Setup (Samsung AutoConfiguration)The Samsung Auto Configuration function lets you connectyour Samsung TV automatically to non-Samsung wirelessAPs. If your non-Samsung AP does not support SamsungAuto Configuraton, you must connect using one of theother methods: PBC (WPS), auto configuration, or manualconfiguration.✎ To use this function, you must setSWL(Samsung Wireless Link) to Off in the TV’s on-screen menu.✎ You can check for equipment that supports SamsungAuto Configuration on www.samsung.com.How to set up using Samsung Auto Configuration1. Place the AP and TV next to each other and turn themon.✎ Because AP booting times vary, you may haveto wait approximately two minutes for your AP toboot up.✎ Ensure the LAN cable is connected to theWAN port of the AP during Samsung AutoConfiguration. If it is not connected, SamsungAuto Configuration only confirms that the TV isconnected to the AP, but does not confirm it isconnected to the Internet.2. After 2 minutes, connect the Samsung Wireless LANAdapter to the TV. When the Samsung Wireless LANAdapter establishes a connection with your TV, a pop-upwindow appears.3. As soon as a connection is established, place the APparallel to the Samsung Wireless LAN Adapter and notfarther than than 9 and 7/8s inches (25cm) from it.4. Wait until the connection is automatically established.✎ If Samsung Auto Configuration does not connectyour TV to your AP, a pop-up window appears onthe screen notifying you of the failure. If you wantto try using Samsung Auto Configuration again,reset the AP, disconnect the Samsung WirelessLAN Adapter and then try again from Step 1. Youcan also choose one of the other connectionsetup methods: PBC (WPS), auto, or manual.5. Place the AP in a desired location.✎ If the AP settings change or you install a newAP, you must perform the Samsung AutoConfiguration procedure again, beginning fromStep 1.or