Samsung CK3366ZR4X/BWT Service Manual

Alignment and AdjustmentsSamsung Electronics 4-94-2-4 (F) TTX MICOM (SZM-191ER) OPTION TABLE (FOR RUSSIA, OCEANIA)BYTEBYTE0BYTE1BITD7D6D5D4D3D2D1D0D7D6D5D4D3D2D1D0LOW (0)16:9 not functional during zoom inthe A/V mode (NORMAL-ZOOM)CH Up/down functional in the A/Vmode (SCART Jack)SOUND-I SYSTEM USEDHIGH (1)16:9 functional during zoom in theA/V mode (NORMAL-ZOOM-16:9)CH Up/down not functional in theA/V mode (RCA Jack)SOUND-I SYSTEM NOT USEDTDA8374ANOT USEDNOT USEDNOT USEDTDA8842English ONLYAFT ON (always)Existing Sharpness level(when using TDA6108 RGB AMP)No Auto Power OnNTSC : 25KHz (NTSC TABLE)PAL : 50KHz (PAL TABLE)English/RussianAFT OFF (after fine tuning)Sharpness level up (when using theTDA6107Q RGB AMP)Auto Power OnNTSC : 25KHz (NTSC TABLE)PAL : 27KHz (PAL TABLE)Application MICOMFIX : LOWBASIC : LOWFIX : LOWBASIC : LOWIC201(ONE-CHIP) OPTIONFIX : LOWLanguage optionBASIC : LOWBASIC : HIGHBASIC : HIGHALL (RF VOL. CURVE) , BASIC :LOW(AV VOL. CURVE: PAL CURVE)Initial sound system during theauto search (All should be set forthe system which is selected dur-ing the Factory Reset.)Note : Unavailable during the CBmodel in the Byte 0COLOR SYSTEMD200D1011 01 1SOUND SYSTEMCK : AUTO (No OSD)CW : -. RF : AUTO→PAL →SECAM→NT4.43-. A/V : AUTO→PAL→SECAM →NT4.43 →NT3.58CB : -RF : PAL ONLY (No OSD)-A/V : AUTO→PAL →NT4.43→NT3.58CS : - RF : AUTO→PAL →SECAM →NT4.43→NT 3.58-A/V : AUTO→PAL →SECAM →NT4.43 →NT3.58B/G→D/KB/G→D/K → IB/G OSDB/G→D/K → I→NT → Ml Function Required : 1. PICTURE OFF (after 15 minutes) during no signal 2. AUDIO MUTE during no signal3. BLUE SCREEN ON/OFF 4. No TIMER CLOCKl The SZM191ER is to be diverted to Australia/New Zealand because of the non-functionality of RGB (of pin 21).(OPTION BYTE : 55/1C)→ When using TDA8842 N1, the BLOOMING check is required.SystemDIGD/KINT-MD10011D00101