Samsung CW-21Z573B Owner's Instructions Manual

English - 344.5 SystemThis menu consists of 5 sub-menus:Product Information, Signal Information, Software Upgrade,Common Interface, and Reset.− Product InformationYou can view your product information. For service or repair,please contact a Samsung approved dealer. Press the ENTER button with Product Informationselected. The product information menu is displayed.− Software Version / Firmware Version− Signal InformationYou can get information about the signal status. Press the ENTER button with Signal Informationselected. The technical information for signal status isdisplayed.− Service / Service ID / Multiplex / Network / Bit errorlevel / Signal Strength− Software Upgrade (Option)To keep your product up-to-date with new digital televisionfeatures then software upgrades are periodically broadcastas part of the normal television signal. It will automaticallydetect these signals and display the software upgradebanner. You are given the option to install the upgrade. Software InforamtionPress the ENTER button, then the current softwareversion is shown. To display the software versioninformation, press the ENTER button again. Manual UpgradePress the ENTER button to search for new software fromthe currently broadcasting channels. Standby Mode upgrade : On / OffPress the ENTER button. To continue software upgradewith master power on, Select On by pressing the ▲ or▼ button.45 minutes after entering standby mode, a manualupgrade is automatically conducted. Since the powerof the unit is turned on internally, the screen may beon slightly for the PDP product. This phenomenon maycontinue for more than 1 hour until the software upgradeis completed.Continued...Time ZoneSystem SetupMove Enter ReturnProduct Information Signal Information Software Upgrade Common Interface Reset SystemMove Enter ReturnSoftware Version: T_BDXPDEU00_0710Firmware Version: T_STDEU7_102cProduct InformationReturnService: ?Service ID: 0000Multiplex: ? (TSID 0000,ONID 0000)Network: ? (ID 0000)Bit error level: 10Signal Strength: 0Signal InformationReturnSoftware Information Manual Upgrade Standby Mode upgrade : On Software UpgradeMove Enter Return