136Network77 Network11 Enter the first portion of the IP Address (for example, 105) into the first entry field using the numberkeys on your remote. Press the button to go to the next field.12 Enter the next portion of the IP Address. Press the button to go to the next field.13 Repeat the entry process for each field in the IP Address.If you make a mistake when entering a number, re-enter the number to correct it. You can alsopress the or button to change the number one unit at a time.14 When done entering the IP Address, press [ ].15 Press the button to go to the Subnet Mask fields, and then press [ ].16 Repeat the same entry process for Subnet Mask, Gateway, and DNS Server.17 When done, select OK at the bottom of the page, and then press [ ]. The network connectionscreen appears and the verification process starts. When the connection has been verified, the“Internet is connected successfully.” message appears.7.1.5 WPS(PBC)How to set up using WPS(PBC)If your router has a WPS(PBC) button, follow these steps:1 Go to Network Setting screen.2 Select WPS(PBC), press [ ], and then press [ ] again.3 Press the WPS(PBC) button on your router within 2 minutes. Your product automatically acquires allthe network setting values it needs and connects to your network.4 The network connection screen appears, and network setup is done.7.1.6 One Foot ConnectionThe One Foot Connection function lets you connect your Samsung product automatically to a Samsungwireless routers. If your wireless router does not support One Foot Connection, you must connect usingone of the other methods.You can check for equipment that supports One Foot Connection on www.samsung.com.How to set up using One Foot Connection1 Turn on the Samsung wireless router and the product.2 Go to Network Settings screen.3 Select One Foot Connection, and press [ ], then press [ ] again.4 Place the wireless router in parallel with and no farther away than 25cm(about 9 3/4 inches) ofSamsung Wireless Adapter.
