ŝ10ŞConnecting to a Power SourceInserting the memory cardƈ Insert the memory card as shown.- Turn off the camera’s power beforeinserting the memory card.- Have the front of the memory cardfacing toward the back of the camera(LCD monitor) and the card pins towardthe front of the camera (lens), and thenpush the memory card into the card slotuntil you hear a click.- Do not insert the memory card thewrong way round. Doing so maydamage the memory card slot.ƃ Before inserting any cables or AC adapter, check the directions and do notinsert by force. It may cause breakage of cable or camera.ƃ If the charging LED of the AC Charger does not turn on or blink afterinserting the rechargeable battery, please check whether the battery isinserted correctly.ƃ If you charge the battery with the camera power on, the battery can't chargefully. Turn the camera off while charging the battery.CAUTIONƈ Charging LED of the AC Adapterƃ A USB cable for transmitting data can’t be used for charging the rechargeablebattery.ƃ A USB cable for recharging the battery is optional.- When the USB cable for recharging the battery is inserted into the connectionterminal of the camera, you can charge the battery and transmit data at thesame time.ƈ Charging time (When the camera is turned off)- Using the AC Charger : About 150MINCharging LEDBeing Charged Red LED is onCharging is complete Green LED is onCharging error Red LED is off or blinkingƃ If you insert the fully discharged battery to charge it, do not turn on the cameraat the same time. The camera may not be turned on because of the lowbattery capacity. Charge the battery for more than 10 minutes before usingthe camera.ƃ Do not attempt to use the flash frequently or take a movie clip when a fullydischarged battery has only been re-charged for a short time. Even if thecharger is inserted, the camera power may turn off automatically during usebecause the partially recharged battery has insufficient power.INFORMATION