first station to hang up, simply press another DSS button. ORPress the CALL button or C.O. line button to return to the outside party andbegin the transfer process again.When you are transferring a call to a keyset set for Voice Announce or AutoAnswer, the transferred call will always ring.NOTES:1. After the inside party answers, you may alternate back and forth between theparties by pressing the TRANSFER button.2. If you receive No More Calls tone, that station has no button available to re-ceive another call. Press TRANSFER to return to the other party.3. You cannot transfer an Intercom call by pressing a DSS button.You must pressthe TRANSFER button and dial the destination extension number.TRANSFER WITH CAMP-ONWhen you are transferring a call to another station and you receive a busy signal,you may camp the call on to this station. Simply hang up when you hear the busysignal. The called party will be alerted that a call is waiting for them.NOTE: If you receive No More Calls tone, that station has no button available toreceive another call. Press TRANSFER to return to the outside caller.TRANSFER TO VOICEMAILThis feature is used to send a call directly to a voice mailbox.Your keyset must havea correctly programmed VT button to accomplish this. To transfer a call directly toa voice mailbox:• While on a call, press the VT button and dial the mailbox number.• Hang up when dialing is completed.CALL WAITINGIf an outside call has been camped-on to your phone or another station hascamped-on to you:• You will hear a tone in the earpiece and the call that is waiting for you(camped-on) will flash. In addition the bottom line of the display will indicatethe number of the station or trunk party camped-on.• Press the flashing button to answer; your other call will go on hold automati-cally if your station has the Automatic Hold feature set. If not, you must pressHOLD and then the flashing button ORFinish the first call and hang up; the waiting call will ring.18