E-13ENGLISHESPAÑOLITALIANOITALIANOPORTUGUÊSDEUTSCHEΛΛHNIKARUSSIANDrain Hose InstallationWrap the drain hose with the insulation drain as shown in figure and secure it.3Install the drain hose so that its length can be as short as possible.Internaldiameter of the drain hose should be the same or slightly biggerthan theexternal diameter of the drain hose port. Inner diameter of the drain hose2 Give a slightly slant to the drain hose for proper drainage ofcondensate. Fix the flexible hose to the PVC with the supplied cable ties-ecurely.Note32mm(Inner diameter)CAUTIONMust fit tightly againstbodywithout any gap.Insulation cover drainNo gapInsulation drain hoseCable-TieIndoorUnitCare must be taken when installing the drain hose for the indoorunitto ensure that any condensate water is correctly drained outside.Thedrain hose can be installed to the right of the base pan.Insert the flexible hose to the drain hose port.1 Fix the flexible hose to the indoor unit with the suppliedcableclamp securely.(Use the screwdriver to fix the flexible hose securely.)NoteCableClampCAUTIONDo not apply force to the piping on the unit sidewhen connecting the drain hose. The hose shouldnot be allowed to hang loose from its connection tothe unit. Fasten the hose to a wall, frame or othersupport as close to the unit as possible.When not installing the drain pumpDo not give the hose and upward gradientafter the connection port.This will cause water to flow backwards whenthe unit is stopped, resulting in water leaks.When installing the drain pumpIf it is necessary to increase the height of thedrain hose somewhat, the portion directly after75cm. If it is raised higher than 75cm, there canbe water leaks.Ceiling75cm or lessUpward gradienCeilingSupport piecesCeilingDB98-27157A(1)_E.indd 13 2007-1-23 13:06:40