E-31ENGLISHESPAÑOLITALIANOITALIANOPORTUGUÊSDEUTSCHEΛΛHNIKARUSSIANWired remote controllerIf an error occurs, is displayed on the wired remote controller.If you would like to see an error code, press the Test button.Display Explanation RemarkCompressor down due to protection control of the discharge-temperature sensorError about protection control ofthe outdoor unitControl due to the condenser temperature sensor whencoolingmodeError of the low pressure switch (Protection control)Reverse phase error (Protection control)In removing frostError of the outdoor temperature sensor (Open/Short) Error about the outdoor unitsen-sor (Open/Short)Detection dur-ing the operation of the indoorunit(sensing and sending errors-into the communication data)Error of condensor temperature sensor (Open/Short)Error of discharge temperature sensor (Open/Short)-System down caused by communication error after comple-tionof tracking- Mismatching of the indoor unit numbers setwith those communication after completion of 5 times trackingCommunication and theindoorunit errorsError of temperature sensor in the indoor unit (Open/Short) Self-diagnosis of theindoor andoutdoor unitError of the heat exchanger sensor in the indoor unit (Open/Short)Error of electronic expansion valve open in the outdoorunit(when it is detected more than once)Error of electronic expansion valve close in the outdoorunit(when it is detected more than once)Error of communication between the indoor unit and the wire-dremote controllerWired remote controllererrorsMaster wired remote controller�Slave wired remote controllerCOM1/COM2 Cross-installed errorError of setting option for wired remote controller COM2DB98-27157A(1)_E.indd 31 2007-1-23 13:07:08